MUTOH Rockhopper II Series Specifikace stáhnout pdf (Strana 206)

Rockhopper II series printers – Maintenance Manual

207

AP-74065, Rev. 1.2, 27/09/04

6.3.3. MAC address write enable menu

It could happen that the computer cannot make connection with the Rockhopper II printer. If this is the case,

the MAC address of the Rockhopper II printer has probably been set to zero or incorrect.

To insert the MAC address into the Rockhopper II printer, please follow the instructions mentioned below.

Notes :

¾ For the MAC address, a unique number is assigned for each unit. Do not use this

function except when intending to recover following deletion of the MAC address.

¾ Please note that this procedure is only available onto the Rockhopper II printers with

following firmware version or higher.

 Rockhopper II : V2.00

6.3.3.1. Request correct MAC address

Step 1 : Remove the Right Cover.

Step 2 : Remove the Ethernet Board Cover.

Step 3 : Onto the installed card you can see a sticker with a ‘FM0 number’.

Notes :

Write down this number ‘FM0 xxxxxx’. Important are the 6 digits ‘x’.

Step 4 : Based on this number Mutoh Europe’s service department can provide you the correct MAC

address for your printer.

Step 5 : Reinstall the covers.

6.3.3.2. Insert the MAC address into the printer

Step 1 : Power on the unit in a special mode. Press the [POWER] key to power ON the unit, while

simultaneously holding the [F1], [F3] and [Menu ↑] key.

Step 2 : The unit will start up in special mode. Following message will appear on the display.

* Counter *

Indication InitMenu

F3 →

MACaddress

Step 3 : Press the [F3] key to select the option ‘MAC Address’. Following message will appear on the

display.

* MAC address *

Input Password

Step 4 : Press the [F2] key.

1 2 ... 201 202 203 204 205 206 207 208 209 210 211 ... 318 319

Žádné komentáře

MUTOH Rockhopper II Series Specifikace Strana 206